This product is not available for new orders.
| Services Available |
|---|
Visão Geral
the 17206 is an SC-IRDA infrared interface factory installed in the enclosure bulkhead. When you purchase an enclosure and the 17206, Campbell Scientific will install the SC-IRDA in the enclosure bulkhead before the enclosure leaves the factory.The SC-IRDA is secured and sealed in the enclosure with a compression fitting. The SC-IRDA is an infrared interface that facilitates communication between the data logger and an infrared-equipped PDA. This device allows you to interrogate the data logger on site without opening the enclosure.
Leia maisBenefícios e Características
- Weather resistant to protect instruments
- Interrogate the data logger on site without opening the enclosure
imagens
Produtos Relacionados
Descrição Técnica
The 17206 must be ordered at the same time as a standard or prewired enclosure. When the 17206 is ordered, Campbell Scientific will install an SC-IRDA Infrared Interface in the enclosure's case. The SC-IRDA provides an infrared interface that facilitates communication between the data logger and an infrared-equipped PDA. This device allows you to interrogate the data logger on-site without opening the enclosure. PConnect software or PConnectCE software is required. The SC-IRDA is secured and sealed in the enclosure with a compression fitting.
Compatibilidade
Please note: The following shows notable compatibility information. It is not a comprehensive list of all compatible products.
Data Loggers
| Product | Compatible | Note |
|---|---|---|
| 21X (retired) | ||
| CR10 (retired) | ||
| CR1000 (retired) | ||
| CR10X (retired) | ||
| CR200X (retired) | ||
| CR206X (retired) | ||
| CR211X (retired) | ||
| CR216X (retired) | ||
| CR23X (retired) | ||
| CR295X (retired) | ||
| CR3000 (retired) | ||
| CR500 (retired) | ||
| CR5000 (retired) | ||
| CR510 (retired) | ||
| CR800 (retired) | ||
| CR850 (retired) | ||
| CR9000 (retired) | ||
| CR9000X (retired) |
Especificações
| Power | Supplied by data logger 5 V (on CS I/O port) |
| Typical Current Drain |
|
| Baud Rate |
9600 (default) Rates up to 19200 selectable via software. |
| Communication Range | Up to 20 cm (8 in.) with typical lighting |
| Acceptance Angle | 30º |
| Communication Standard | Conforms to the IRDA low power SIR specifications as supported by most Palm PCs and laptops. |
| PDA Handheld Requirements | Must have an IRDA sensor and an IR chipset compatible with the SC-IRDA. (See PConnect or PConnectCE product brochure for other PDA requirements.) |
| CE Compliance | Complies with EMC standard EN61326:1996. |