Toggle navigation
Produtos
Solutions
Suporte
Sobre Nós
Casa
Produtos
Solutions
Suporte
Sobre Nós
Cotação
Contato
Websites regionais
Websites regionais
Africa
Australia
Brasil
Canada
Centro Caribe
Deutschland
España
Europe
France
India
Japan
United States
ภาษาไทย
中国
Diretório país
Log In
FAQs
Frequently Asked Questions about Our Products and Solutions
Faça uma Pergunta
Faça uma Pergunta
Pesquisa
All FAQs
(1967 total: showing 1641-1660)
Are the intake heaters of the AP200 wired in series or in parallel?
Can bulk cable be purchased and cut to length in the field?
What kind of cable is recommended for the intake heaters of an AP200?
Why are some tubes difficult to connect, requiring a wrench to completely tighten the nut? Can something be done about this?
Why are inserts recommended for the tubing?
Do the intake tubes on the AP200 have to be the same length?
How long can the intake tubes be on an AP200?
If fractional tube sizes are not available, can 6 mm tubing be used instead on the AP200?
Can standard polyethylene tubing be used for an AP200?
Does the tubing for an AP200 have to be bought from Campbell Scientific?
What is the recommended tubing for an AP200?
Why will the tubing not go into the ¼ in. fitting on a regulator?
Can someone from Campbell Scientific come to a site and install an AP200 system?
Can Campbell Scientific assemble the fittings onto the tubes?
How are Swagelok tubing connections made?
What is a Bowen ratio, and can an AP200 measure it?
Can the AP200 be used with chambers?
Can the AP200 be used to measure horizontal advection?
Why does the AP200 require an ambient pressure measurement for the H
2
O span, but not for the zero or CO
2
span?
Why would CAL_TIMEOFFSET ever be set to a non-zero value?
Anterior
Próximo