Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CELL210 Problem


Larry@UFL Jul 16, 2019 08:12 AM

Hello All,

I have multiple CELL210's and we are using a Private IP Verizon account here at the University of Florida. I discovered that if you include more than one 'trusted IP address' the CELL210 will not pass and data to the datalogger. Fortunately, all out LoggerNet servers have the same IP address so only a 'wildcard' is needed at the end of the trusted address.

Since we are using old CR10X's and set the BAUD rate to 9600 baud, we can use our old SC932A's and the even older SC932's even the new SC105 without any problem.

Regards,

Larry Treadaway - University of Florida / IFAS Office of Information Technology


JDavis Jul 16, 2019 03:22 PM

Is that with OS version 1 or version 2 on the CELL210?


GaryTRoberts Jul 16, 2019 03:41 PM

We were able to reproduce the issue this morning. The fix for this issue will be in the next release of the modem's operating system.


Larry@UFL Jul 17, 2019 05:19 AM

Reply to JDavis, OS Version 1 as there is no OS Version 2 as far as I know.

Larry@UFL


Larry@UFL Jul 17, 2019 05:21 AM

Correction to JDavis, there is a OS Version 2, apparently they created it last week.

Larry@UFL


Larry@UFL Jul 17, 2019 06:17 AM

To Everyone, apparently when you put in any Trusted Addresses, the modem will not pass data to the datalogger.

Larry@UFL

Log in or register to post/reply in the forum.