All FAQs (1723 total: showing 361-380)
- To replace the transducer heads on an SR50A-L, is there a torque specification for the screws?
- Can the SR50A-L be recalibrated?
- If an SR50A-L is used to measure snow depth at a site that has wind, rain, and extreme changes in temperature, which results in condensation, what can be done to ensure the sensor operates properly?
- Can an SR50A-L be hardwired to a data logger that is 2,000 ft away with no direct line of sight?
- How can snow depth less than 0.5 m be measured using an SR50A-L?
- Can the range operation of the SR50A-L be increased?
- Can the SR50A-L handle a coastal environment with humidity and salt spray?
- Can the SR50A-L be used in small-diameter wells?
- Can an SR50A-L be connected to a data logger on an SDI-12 port?
- Does the SR50A-L need a temperature probe?
- To use the CPEC200/310 scrub module as a source of zero gas, is it necessary for the CPEC200/310 system to include a valve module?
- Is there a calibration procedure for the PWS100?
- At a consistently windy site, is a PWS100 less accurate than a tipping bucket rain gage?
- How can a copy of the PWS100 Present Weather Viewing Software be obtained?
- What does the Present Weather Viewing Software do? For example, can it save data?
- Can a PWS100 be used to measure visibility? If so, can it be used in a sandy area such as the Sahara Desert?
- What is the current drain of the PWS100?
- How is the PWS100 different from a rain gage or snow depth sensor?
- Can an HFP01SC provide correct running averages if the scan rate is reduced to 1 minute?
- If Short Cut does not list the TCAV on its sensor list, what should be done?
Anterior
Próximo