Toggle navigation
Produtos
Solutions
Suporte
Sobre Nós
Casa
Produtos
Solutions
Suporte
Sobre Nós
Cotação
Contato
Websites regionais
Websites regionais
Africa
Australia
Brasil
Canada
Centro Caribe
Deutschland
España
Europe
France
India
Japan
United States
ภาษาไทย
中国
Diretório país
Log In
FAQs
Frequently Asked Questions about Our Products and Solutions
Faça uma Pergunta
Faça uma Pergunta
Pesquisa
All FAQs
(1723 total: showing 281-300)
Can the OBS-3+ be installed on a pipe?
Can the signal from an OBS-3+ or OBS300 be read directly without the use of a data logger?
What is the minimum water depth in which the OBS-3+ or OBS300 can be installed?
Can the OBS-3+ withstand dry weather conditions and work properly if it is not submerged in water all the time?
How is an OBS300 sensor secured?
Can the OBS300 withstand dry weather conditions and work properly if it is not submerged in water all the time?
What is the difference between the OBS-3+ and the OBS300?
How do the RF401A and RF411A compare with their predecessors?
Can a COM220 and an RF401A coexist on a CS I/O terminal?
How many CR206X dataloggers can one RF430 communicate with?
Can an RF401A be used as a base radio to communicate with RF400 devices, as well as with a PakBus network of CR206X dataloggers?
Is there an RF filter for an RF401A or RF450 that can be used to clean up local interference?
What is the maximum number of AVW206 devices that can be connected to one RF401A?
How can an RF401A be used to communicate as both a sender and a receiver with an RF400?
Is there a way to remotely connect to an RF401 to correct an Active Interface setting in the Device Configuration Utility?
Is there a Status table for the RF401?
How is callback programming done using an RF401A?
Can an RF401 handle high-frequency data, such as 10 Hz?
Is it possible to remotely change the settings of a remote RF401A, such as through a radio-to-radio transmission?
If two RF401A radios are using different operating systems, does that affect their ability to communicate?
Anterior
Próximo