All FAQs (1966 total: showing 1861-1880)
- If the 21X was turned off before the data was downloaded using PC208W, what can be done?
- Do the 21X dataloggers have a built-in security code that might be activated under certain conditions when upgrading the program?
- Can the CR5000 store data with a rate of 1000 Hz?
- What happens to a 21X program when the batteries fail?
- Is the 03101-L capable of delivering a 0 to 5 Vdc square wave output for the wind speed?
- How do the 014A-L 3-Cup Anemometer and 03101-L Wind Sentry Anemometer compare?
- Using a 229-L with a CR1000, can the system be programmed to read the equilibrium soil temperature before excitation for a matric potential measurement?
- Do heater resistance values of 37 to 48 ohm indicate a problem with the 229-L, or are those values within the normal range?
- Is there a limit to how much memory the CR5000 can access/use through the PCMCIA interface?
- Is it possible to transfer data from PC400 directly to a database such as Oracle (possibly through ODBC on Windows)?
- What is needed to upgrade PC208 software to PC400 software?
- What might cause the 014A-L to miss data, provide readings of 0 constant wind speed, and show various readings of gust speed?
- Is the CC640 a real-time camera?
- Is it possible to watch real-time online images using the CC640 and a suitable data logger? How it is possible to retrieve data from the camera, as there is only one RS-232 terminal on the data logger, which is usually used for a GPRS device?
- Can a digital camera be used with an RF network to transmit images back to the office using LoggerNet?
- Is there an existing port on the CR10X that can house a RS-232 one-wire interface device?
- Is there a minimum 12-channel data logger available that can send data to an Internet server by GPRS?
- Is the observational data maintained in a CR10X if ac power is lost when data is written in the final storage area? Can the data of the final storage area be read by an internal program when ac power is restored?
- Can the CR10X communicate piezometer data easily with a Wonderware SCADA system for data display?
- Can the CR10X send data out the serial port to be parsed by another instrument? If so, is this automatic, programmed, or a response to a command from another instrument?
Anterior
Próximo