FAQs Frequently Asked Questions about Our Products and Solutions

Faça uma Pergunta Faça uma Pergunta

All FAQs (1966 total: showing 1721-1740)

For redundancy purposes, is it possible to have two GSM modems connected to a CR800 or CR850 with each modem on a different cellular provider?
What software is necessary to modify a program built with LoggerNet for an isolated CR800 or CR850?
How can multiple programs for different sensors be sent to a single CR800 or CR850 datalogger?
Can the CR800 be programmed through either a mountable or portable keyboard display?
Is there an Ethernet module available for the CR800 or CR850?
Do the CR200X and CR800 use the same PakBus protocol or a different PakBus protocol?
What is the maximum current that the control port of a CR800, CR850, or CR1000 can source without causing damage?
Does the CR800 or CR850 work with a 2 kHz (maximum) burst mode for the VoltDiff() instruction like the CR1000 does?
Can the battery on the CR800 or CR850 be changed by the user?
How can several SDI-12 instruments be wired to a single data logger terminal?
Can a CR800 wiring panel be used on a data logger other than the original data logger?
What is the maximum supply voltage of a CR800 or CR850 without damaging the data logger?
Is there a device similar to the ACL1 that can handle a 20 to 30 Vac or Vdc input?
Is there a device similar to the ACL1 that has multiple inputs/outputs?
Why do the example programs for the WXT520 use a scan rate of 5 seconds?
Why do the values from the WXT520 seem to be out of order?
If the wind speed on the WXT520 constantly reads 0, what should be done?
Is LoggerNet software needed to download the data from a data logger remotely?
What connects to the data logger RS-232 port?
Can the constants located within the ConstTable/EndConstTable instructions be edited?

Anterior Próximo