Toggle navigation
Produtos
Solutions
Suporte
Sobre Nós
Casa
Produtos
Solutions
Suporte
Sobre Nós
Cotação
Contato
Websites regionais
Websites regionais
Africa
Australia
Brasil
Canada
Centro Caribe
Deutschland
España
Europe
France
India
Japan
United States
ภาษาไทย
中国
Diretório país
Log In
FAQs
Frequently Asked Questions about Our Products and Solutions
Faça uma Pergunta
Faça uma Pergunta
Pesquisa
All FAQs
(1726 total: showing 1141-1160)
Can the SDM-CD16S be used to switch the negative side of dc loads?
Is there a manual override on the SDM-CD8S or SDM-CD16S?
Can an SDM address be changed quickly and easily?
Can multiple SDM-CD8S or SDM-CD16S devices be connected to a single data logger?
If an SDM-CD8S or SDM-CD16S is used to switch an inductive load (solenoid), is a diode needed to protect against voltage kickback, or is one already built into the device?
What is the warm-up time for the CS100 or CS106?
Why might measurements with a CS100 or CS106 be bouncing (noisy)?
Does the CS100 or CS106 need to be vented to the outside of an enclosure or building?
To replace a CS105 with a CS106 in an existing system, does anything extra need to be ordered?
Is the CS106 a direct replacement for the CS105?
How often should the CS100 or CS106 be factory calibrated?
What are the multiplier and offset values used with a CS100 or CS106?
Can a CS100 or a CS106 be enclosed and used to measure air pressure within a snowpack?
Does the CS100 or CS106 fit inside an ENC100 enclosure?
Can a CS100 or CS106 be used to measure pressure in an application at very high humidity without damaging the sensor?
Can the operation of a CDM-VW300 or CDM-VW305 be evaluated in a lab?
Can more than one CDM-VW300-series device be used with one data logger?
What is the CPI bus?
What hardware is needed to make a CDM-VW300 or a CDM-VW305 work?
Using a CDM-VW300 or a CDM-VW305, how can the frequency of the vibrating wire sensor be converted to engineering units of measure?
Anterior
Próximo